Bushings
#1
10-24-2011 | 01:44 AM
Thread Starter
|
Junior Member
Joined: Oct 2011
Posts: 2
Bushings
Hi
I am replacing the front lower controlarm bushings on my 1964 Oldsmobile Dynamic 88.
I have removed the bushings but need some advice regarding the pressing in of the new ones.
The bushings that I have are 2.2" long, 1.52" under shoulder to end, 1.41" dia 1.45" dia under shoulder.
The step under shoulder is .21" long.
When I place the bushings over the pivot shaft the measurement between the bushings shoulders is 12.3/4" but the measurement between the hole shoulders on the control arm is 13".
My questions, have I got the right bushings? (the supplier said I have)
Do the bushings have to be pressed down to the shoulder?
Will the extra1/4" compress?
Thank you for any advice.
Regards
Arnie
Australia
I am replacing the front lower controlarm bushings on my 1964 Oldsmobile Dynamic 88.
I have removed the bushings but need some advice regarding the pressing in of the new ones.
The bushings that I have are 2.2" long, 1.52" under shoulder to end, 1.41" dia 1.45" dia under shoulder.
The step under shoulder is .21" long.
When I place the bushings over the pivot shaft the measurement between the bushings shoulders is 12.3/4" but the measurement between the hole shoulders on the control arm is 13".
My questions, have I got the right bushings? (the supplier said I have)
Do the bushings have to be pressed down to the shoulder?
Will the extra1/4" compress?
Thank you for any advice.
Regards
Arnie
Australia
Thread
Thread Starter
Forum
Replies
Last Post