< src="http://www.google-analytics.com/urchin.js" =text/>
</>
I have just gotten a 2001 Silhouette and was wondering if anyone knows the technique for programming the keyless entry system to add another transmitter without using the Techtool (which I do not have access to) to access the BCM.


You can do this on an Intrigue using a sequence including inserting the key, holding down lock buttons, and pressing buttons on the transmitter.


Does a similar sequence exist for the 2001 Silhouette?


Thanks.


Frank

 

Here is the sequence for an ''01 Silhouette


1. Remove the ignition key from the ign lock cylinder


2. Remove the "BCM PRGRM" fuse from the fuse panel


3. Close all doors and liftgate


4. Insert key into the ign and turn to ACC


5. Turn the ign to OFF and then back to ACC within 1 Second - perform this step as fast as humanly possible.


6. Open and close any vehicle door. A chime will be heard when the system enters the programming mode.


7. Press and hold the transmitter LOCK and UNLOCK buttons simultaneously for 14 SECONDS. After 7 SECONDS a Chime may be heard confirming successful synchronization. It is necessary to wait approx 14 SECONDS for a second chime that will confirm successful programming. Your new remotehas been accepted and all existing remotecodes have been erased.


8. Repeat the previous step on each additional transmitter to be programmed (including any existing transmitters)


9. Remove the ignition key from the ign lock


10. Install the BCM PRGRM fuse back in the fuse panel.


Good Luck,


Corky