car wont run
#1
I can get my car to start but as soon as I step on the gas it dies. It is a 1990 Oldsmobile cutlass supreme coupe. I was wondering if it could need a new fuse in the fuel relay? Or any suggestions? Please help. I do not know any good mechanics! Any suggestions?
#2
try to read this article.. you may find a situation similar to your problem.. good luck http://www.ehow.com/video_112584_tro...-car-wont.html
**********
[img]smileys/smiley11.gif[/img]
hp?act=post&do=rehp?act=post&do=re
Autopartswarehouse kurt E. daniel
rum/forumdisplay.php?f=1/key_/</font>
**********
[img]smileys/smiley11.gif[/img]
hp?act=post&do=rehp?act=post&do=re
Autopartswarehouse kurt E. daniel
rum/forumdisplay.php?f=1/key_/</font>
#3
I''ve had this happen on a two stroke moped... If you have other carbs, put them on and see what happens. Anyway, turn your engine on and leave it running for fifteen minutes. Then touch the gas as slightly as possible... And see if you can get the engine to run on just a bit higher rpm.
I''ve also seen this problem in a snowmobile, two stroke engine, the problem here was that the engine was seized.
Be well!
Travis
I''ve also seen this problem in a snowmobile, two stroke engine, the problem here was that the engine was seized.
Be well!
Travis
#5
Originally Posted by Chona
I can get my car to start but as soon as I step on the gas it dies. It is a 1990 Oldsmobile cutlass supreme coupe. I was wondering if it could need a new fuse in the fuel relay? Or any suggestions? Please help. I do not know any good mechanics! Any suggestions?
Check your fuel pressure and fuel filter
fuel pressure should be around 40 - 47 psi(fuel injectored engines )
To help could you give us which motor you have .the above specs are for the 3.8L , 3.3L & 3.1L.
Thread
Thread Starter
Forum
Replies
Last Post